Also fitted the bigbore piston and cilinder, although it has to come off again because I can't remember if I put the knock pin in. I hope I did because the pistonrings were a pain to get in, when the cilinder was bored out, the sloping edge has disappeared.
Chain tensioner has been put in after this picture was made, but I have to figure out a way to keep the oil-pump sprocket in place as I don't want to use the stator which normally keeps it from moving side to side.
Loosing Slope edge -> I had the same problem and do a new one with the "Dremel"
ReplyDelete--thomas
What's your plans for the ignition
ReplyDeleteWhen the cilinder has to come off, I will make a new edge, my dad told me the same thing.
ReplyDeleteI want to run a battery ignition, with original points. The races are short, so recharching will be done at home.